An Individual employed in this position is considered to possess a prerequisite amount of knowledge, attitude, skills, and habits required to perform procedural tasks under general supervision, and complex tasks involving the use of theoretical knowledge and motor skills under close supervision. Individual must be able to pass X-Ray test on GTAW (tig), FCAW (flux core), and GMAW (mig).  This is a 2nd shift position. 

• Must maintain a high X-Ray percentage of 98% acceptance (for ALL 4 WELD PROCESSES).
• Must be able to perform a complete fit up for work area.
• Must be able to make weld repair per T.D. Williamson’s specifications.
• SAFETY – Employee must wear all required(PPE) Personal Protective Equipment and MUST ABIDE TO ALL TDW (HSE) Health Safety Environment requirements.
• Ability to safely light and use gas torches.
• Ability to safely operate various types of hand grinders.
• Ability to safely operate cranes with good safe knowledge of lifting and rigging procedures.
• GTAW experience – GAS TUNGSTEN ARC WELDING
• FCAW experience – FLUX CORE ARC WELDING
• GMAW experience – GAS METAL ARC WELDING
• SAW experience – SUBMERGE ARC WELDING
• INTRO to FITUP – Welder must understand TWO-HOLE alignment / TWO-HOLE fit up. Which is used and understood by welders associated in the pipe line industry.
• How to use a combination square and level to measure and fit up for concentricity alignment.
• READING PRINTS – Must understand print dimensional locations and tolerances along with weld symbols.
• LOCATING, UNDERSTANDING, and FOLLOWING (WPS) Weld Procedure Specifications.